Found the message brakes are low pn the information center. Confirmed front brakes are down to wear sensor. Will need to replace the front brakes
Replace front brake pads and rotors. Clean and lubricate caliper slides. Clean wheel hubs for correct rotor to hub contact. Check and fill brake fluid. Road test vehicle.
Lynn / Linda K. gave our service a 5 star review on 9/27/2025
needed to jump start the vehicle. Noticed the serpentine belt tensioner is rattly and bouncing. Tested the alternator output, testing low. Alternator is not charging. Verified there is good power and ground to the alternator. All tests are good. Will need to replace the alternator
Performed testing , there is a code P0191 in the computer memory fuel pressure sensor. Noticed while test driving w a vibration while test driving that is corresponding to engine rpm that is transmitted through the fuel lines. We monitored ecm data and fuel line and fuel rail pressures and pressures fluctuate wildly when driving. Recommend replacing the high pressure fuel pump
Raine H. gave our service a 5 star review on 6/6/2024
there is sparks flying from the a/c compressor. Has blown out the fuse also
A/C COMPRESSOR – Remove & Replace – In-Line6 – [DOES NOT include Air Conditioning System recover, evacuate and/or recharge.]
Remove and store refrigerant, evacuate system and add proper amount of lubricant and refrigerant. Reclaim refrigerant prior to system service. Draw vacuum, check for leaks. Recharge with proper amount of lubricant and refrigerant.
Michael S. gave our service a 5 star review on 12/15/2023
Performed testing on the TPMS system. The tires were not programmed to the position of the vehicle correctly. The rear tire pressure was registering on the front. We reprogrammed the TPMS system to the correct position of the tires. Then set tire pressures to the correct pressures,
replace wipers
Mike & Lynn R. gave our service a 5 star review on 11/10/2023
Antilock Brake light is on. C0050-18 and c0050-0F. Testing I used scanner to watched the right rear speed sensor data and found erratic response. Visual inspection found broken magnetic strip. hub/wheel bearing iheck Engine Light on. P16D0 code has TSB out on it. I found TSB testing procedure and everything is testing ok at this time.
Emma M. gave our service a 5 star review on 9/1/2023
P0420 catalyst efficiency – monitored upstream and downstream o2 sensors. Found the upstream is slightly erratic. Downstream sensor had readings of 1.8v when cold, then when warm, it returned to normal range of 0-780mV. The catalyst might be inefficient, but the downstream sensor readings are unreliable. This will need the downstream sensor replaced as step 1. Then the system will be able to better montior the catalyst. There is an odor of raw exhaust under hood so the manifold converter may have a leak anyway.Recommend replacement of downstream o2 sensor as first step
Claudia O. gave our service a 5 star review on 1/27/2023