Name: Lutter's Elmbrook Automotive
Address: 16880 W Greenfield Ave., Brookfield, WI, 53005

2013 Ford Explorer
Mileage
101,205
Service Date
2/3/2026
Services Performed
Inspected the exhaust "puttering" noise. We found the gasket that fits between the converter and the extension pipe. This gasket was replaced when the converter was replaced. Installed a new gasket.
Sandra / Bob L. gave our service a 5 star review on 2/4/2026
2008 Ford Escape
Mileage
147,466
Service Date
1/14/2026
Services Performed
Check progression of serpentine belt from marginal last visit and advise.
.
Rotate and Balance Tires
Four Wheel Alignment
Nancy R. gave our service a 5 star review on 1/15/2026
2007 Ford Expedition
Mileage
153,693
Service Date
1/8/2026
Services Performed
Tested coil and injector on #2 – found the coil has very weak output. Installed a used coil from stock, cleared codes, and test drove. Misfire is gone.
Can see the inner door handle cable is broken. It is less common for the cable to fatigue and break. It is more common for the latch to seize -requiring excessive force on the cable to open the door. We will not know if the latch is good until we disassemble the door
Nathan / Jaime G. gave our service a 5 star review on 1/8/2026
2013 Ford Explorer
Mileage
100,134
Service Date
10/22/2025
Services Performed
P0430 is in memory. Monitored both banks oxygen sensors, short term fuel trim, and long term fuel trim. Fuel trim is ok. The bank 2 downstream sensor did slightly more switching during acceleration during warm up. This is an indication it is weak. Performed a visual inspection on front catalytic converter: found one of the mounting studs is missing and the body is cracked also.
Replace left side exhaust manifold/ catalytic converter assembly
Replace transmission mount
Sandra / Bob L. gave our service a 5 star review on 10/24/2025
2014 Ford Fusion
Mileage
187,068
Service Date
9/29/2025
Services Performed
Replace passenger rear tail light assembly NOTE: the wiring harness was soaking wet and there is corrosian in the connector. We needed to clean the terminals before reassembly
Attila S. gave our service a 5 star review on 10/1/2025
2010 Ford Taurus
Mileage
132,854
Service Date
9/17/2025
Services Performed
Oil and filter change service
SERPENTINE BELT TENSIONER – Remove & Replace – Limited,SE,SEL
Mark / Lora S. gave our service a 5 star review on 9/19/2025
2008 Ford Escape
Mileage
144,234
Service Date
8/1/2025
Services Performed
Performed testing on the check engine . Confirmed the code is a P0420 bank 1 catalytic converter. This code has been noted before and we will need to replace the bank 1 (fire wall side) exhaust manifold /catalytic converter
Replace right side catalytic converter including removal of several broken exhaust manifold bolts and repairing bolts
replace/ repair third brake light assembly
Nancy R. gave our service a 5 star review on 8/2/2025
2016 Ford Edge
Mileage
116,369
Service Date
10/23/2024
Services Performed
Oil and filter change service
Jump started to bring into shop. Tested battery and it failed, removed and replaced battery as needed.
Access cabin filter housing remove old air filter. Clean out housing of debris. Install new filter. Fasten housing.
Replace engine air filter
Rotate and Balance Tires
Cleans, throttle body, fuel injectors, combustion chambers, converters, ionizes carbon from system, promotes better performance and fuel economy, reduces costly repairs
John K. gave our service a 5 star review on 10/24/2024
2010 Ford Explorer
Mileage
161,660
Service Date
8/16/2024
Services Performed
TOWING
inspected the vehicle and with the radiator cap off and cranking the engine coolant is being pumped out the radiator. There is a cylinder head problem.When we first attempted to crank the engine was hydro locked
Joe W. gave our service a 5 star review on 8/16/2024
2011 Ford Ranger
Mileage
88,772
Service Date
7/11/2024
Services Performed
Oil and filter change service
brake inspection, has noticed squeaking from the left rear
STABILIZER BAR CONTROL LINK – Remove & Replace – Both
BALL JOINT – Remove & Replace – RWD Lower,One Side – [DOES NOT include wheel alignment. Includes: R&I Spindle.] – [DOES NOT include alignment.]
DISC ROTOR – Remove & Replace – RWD Front,Both – [Includes: Repack Wheel Bearings (where applicable) and replace Pads (if necessary). DOES NOT include refinishing.]
Clean the master cylinder cap area and remove the old fluid from the reservoir. Fill with fresh fluid and flush with power brake flush machine by pressurizing brake master cylinder and vacuuming old fluid out of each brake bleeder until the fluid is clean
Replace rear brake pads and rotors. Clean and lubricate caliper slides. Clean wheel hubs for correct rotor to hub contact. Check and fill brake fluid. Road test vehicle.
overlap labor between front brakes and ball joint
Remove fluid from the entire system and the reservoir. Refill the system with new fluid designed to exceed OE performance specifications.
Barry K. gave our service a 5 star review on 7/11/2024

Ford