Replace water pump and all 3 timing chains, all 3 tensioners, and all guides. Replace front crankshaft seal also.
We also replaced the power steering pressure hose as it was seized to the rack, and the suction hose as it was swollen
Replace rear brake pads and rotors. Clean and lubricate caliper slides. Clean wheel hubs for correct rotor to hub contact. Check and fill brake fluid. Road test vehicle.
Rotate and Balance Tires
Road test vehicle. Check all suspension and steering parts for wear. Check tire pressure and condition. Check riding height. Check alignment of all four wheels. Adjust caster, camber, toe-in, and thrust angle as needed on all four wheels. Center steering wheel .
Oil and filter change service
Mark / Lora S. gave our service a 5 star review on 2/10/2023
There is several transmission trouble codes in the computer memory. P0606 transmission control processor, and a code P06b2 transmission control module ram. Cleared the codes in the transmission. module/ ecm. Drove several times. Seemed to drive good and no codes returned
Patrick K. gave our service a 5 star review on 1/17/2023
Inspected the vehicle for coolant leaks. Pressure tested and found water pump leaking from the weep whole. Will need to replace the water pump. This is run off the timing chain. Very labor intensive job
Thomas G. gave our service a 5 star review on 12/27/2022
there is a trouble code P1450 in the computer memory. There is a purge valve issue. Performed the pinpoint testing found there is a purge valve issue. Will need to replace the purge valve
Replace canister purge solenoid
Oil and filter change service
Dylan F. gave our service a 5 star review on 10/10/2022
Road test and verify engine performance, transmission operation, and shift patterns. Flush transmission which includes: flushing of transmission cooler, cooler lines, valve body, and torque converter. Flush all contaminated fluid out and replace with f
Oil and filter change service
John K. gave our service a 5 star review on 7/14/2022
Vehicle started and ran rough. Codes P0302 & P0316 present. Checked plug and coil. Coil had failed and when removing #2 plug, the previously repaired thread insert (in head) came out with plug. The plug and insert did not want to separate. Reinstalled plug with insert, replaced coil with used part, and retested. Misfire is gone and vehicle accelerates and cruises normally. The idle is a bit rough feeling. All cylinder contributions are +/- 2. This is acceptable.
Henry R. gave our service a 5 star review on 6/15/2022