Inspected the exhaust "puttering" noise. We found the gasket that fits between the converter and the extension pipe. This gasket was replaced when the converter was replaced. Installed a new gasket.
Sandra / Bob L. gave our service a 5 star review on 2/4/2026
Tested coil and injector on #2 – found the coil has very weak output. Installed a used coil from stock, cleared codes, and test drove. Misfire is gone.
Can see the inner door handle cable is broken. It is less common for the cable to fatigue and break. It is more common for the latch to seize -requiring excessive force on the cable to open the door. We will not know if the latch is good until we disassemble the door
Nathan / Jaime G. gave our service a 5 star review on 1/8/2026
performed testing and there is trouble codes P0304 cylinder #4 miss fire, P0306 cylinder #6 miss fire and a code P0300 random cylinder miss fire. While inspecting noticed the engine bay is filled with leafs and also observed a rodent nest. Gained access to the cylinder heads and can see several wiring pig tails chewed in half. Will need to replace the 2 coil harnesses. On the test drive after repairing the harness with the scanner installed did notice very slight cylinder miss fires on cylinders 1,5 and 7. Possibly due to carbon build up in the intake valves. We cleaned the rodent nests out. The low windshield washer light is on. Installed 1 gal of washer solvent however the washer solvent light remained on. Found the wiring pig tail for the washer solvent level sensor also chewed up. Replaced harness
splice in both coil pig tails and windshield washer level sensor pig tail
Ron M. gave our service a 5 star review on 1/2/2026