Call (262) 782-7825

Go to…

Mitsubishi

Home / Mitsubishi

We Service and Repair all Mitsubishi cars

  • 2008 Mitsubishi Endeavor

    Mitsubishi Endeavor
    Mileage
    148,448
    Service Date
    7/6/2022
    Services Performed
    • Performed full module scan: B1408 Front right impact sensor. There were many U codes in multiple other modules. Switched RF and LF impact sensors to see if code would follow position. However, no codes or warning lamps returned. There was either a connection problem or an intermittent fault with sensor.
    • Open the evap drain to allow condensation to drain
     
    Tom L. gave our service a 5 star review on 7/12/2022

  • 2011 Mitsubishi Outlander Sport

    Mitsubishi Outlander Sport
    Mileage
    80,565
    Service Date
    9/5/2019
    Services Performed
    • Access cabin filter housing remove old air filter. Clean out housing of debris. Install new filter. Fasten housing.
    • Road test and verify engine performance, transmission operation, and shift patterns. Flush transmission which includes: flushing of transmission cooler, cooler lines, valve body, and torque converter. Flush all contaminated fluid out and replace with f
    • Rotate and Balance Tires
    • Cleans, throttle body, fuel injectors, combustion chambers, converters, ionizes carbon from system, promotes better performance and fuel economy, reduces costly repairs
    • Check brake fluid for moisture and contamination. Inspect all hydraulic line and hoses. Inspect calipers and wheel cylinders. Inspect master cylinder and cap. Flush entire brake system including master cylinder, calipers, wheel cylinders until clean.
     
    Andrew B. gave our service a 5 star review on 9/9/2019

  • 2004 Mitsubishi Endeavor

    Mitsubishi Endeavor
    Mileage
    82,988
    Service Date
    6/14/2019
    Services Performed
    • Inspect Brakes
    • Check brake fluid for moisture and contamination. Inspect all hydraulic line and hoses. Inspect calipers and wheel cylinders. Inspect master cylinder and cap. Flush entire brake system including master cylinder, calipers, wheel cylinders until clean.
    • Replace front brake pads and rotors. Clean and lubricate caliper slides. Clean wheel hubs for correct rotor to hub contact. Check and fill brake fluid. Road test vehicle.
    • Place vehicle on alignment rack, attach equipment, measure caster, camber and toe. Compare to vehicle specifications. Set and adjust all approved alignment angles with allowable specifications.
    • Replaced axle assembly
    • Replaced front strut cartridges and mounts
    • Replaced strut cartridges and mounts
    • Mount and balance four tire/wheel assemblies.
     
    Pennie S. gave our service a 5 star review on 6/20/2019